MB7ILM Information
License details.
Callsign | MB7ILM |
Transmitter Frequency | 145.3625 MHz |
Receiver Frequency | 145.3625 MHz |
CTCSS Access Tone | 82.5Hz on Receive and Transmit |
Modes | FM-Narrow 2.5KHz deviation |
Antenna | Diamond X50 |
Antenna Height Above Ground | 8m |
Maximum Antenna ERP | 7 dBW, 5W |
Responsible Licensee | M0DKR |
Radio Settings.
MB7ILM 2m gateway is one of the new non-NOV gateways allowed by the licence changes in February 2024.
To use a simplex gateway you need to listen and transmit on the same frequency, MB7ILM 2m Gateway transmits and receives on 145.3625MHz and requires a CTCSS tone of 82.5Hz.
MB7ILM 2m gateway is permanently linked to GB3RF while it is tested but may move in the future.
All simplex gateway nodes are licensed for narrow deviation only so please make sure your radios are set to narrow. If you operate your radio in wide deviation mode you could cause distortion and your signal may be dropped by the gateway radio. Leave a gap of four seconds between overs to allow all linked nodes to reset and for anyone else to join in. Before transmitting into a gateway please listen for a while to make sure it's not in use. Two people can use the same gateway to talk with other users but as it's only simplex you will be hearing the other local user directly from their radio to yours.
The tones from the gateway assist with determining who is operating from where.
When you transmit into the repeater and it's connected to another node, as you unkey, the gateway will reply with a morse K (dah-dit-dah) with a higher frequency of 1200Hz.
When you transmit into the repeater and it isn't connected to another node, as you unkey, the gateway will reply with a morse K (dah-dit-dah) with a lower frequency of 800Hz.
When a remote user on the network ends transmission you will hear a morse I ( dit-dit).